HP MSR2000/3000/4000 Router Series MPLS Configuration Guide
225
Ste
p
Command
Remarks
4. Enable IPv6 for the IS-IS
process.
ipv6 enable IPv6 is disabled by default.
5. Return to system view.
quit N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Enable IPv6 for the IS-IS
process on the interface.
isis ipv6 enable [ process-id ]
IPv6 is disabled on an interface by
default.
Configuring EBGP between a PE and a CE
1. Configure the PE:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enable BGP and enter BGP view.
bgp as-number N/A
3. Enter BGP-VPN view.
ip vpn-instance vpn-instance-name N/A
4. Configure the CE as the VPN
EBGP peer.
peer { group-name | ipv6-address }
as-number as-number
By default, no BGP peer is
configured.
5. Create and enter BGP-VPN IPv6
unicast address family view.
address-family ipv6 [ unicast ]
Configuration commands in
BGP-VPN IPv6 unicast
address family view are the
same as those in BGP IPv6
unicast address family view.
For details, see Layer 3—IP
Routing Configuration Guide.
6. Enable IPv6 unicast route
exchange with the specified peer
or peer group.
peer { group-name | ip-address }
enable
By default, BGP does not
exchange IPv6 unicast routes
with any peer.
7. Redistribute the routes of the
local CE.
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
A PE must redistribute the
routes of the local CE into its
VPN routing table so that it
can advertise them to the peer
PE.
8. (Optional.) Configure filtering of
advertised routes.
filter-policy { acl6-number | prefix-list
ipv6-prefix-name } export [ protocol
process-id ]
By default, BGP does not filter
advertised routes.
9. (Optional.) Configure filtering of
received routes.
filter-policy { acl6-number | prefix-list
ipv6-prefix-name } import
By default, the PE does not
filter received routes.
2. Configure the CE:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Configure the PE as an EBGP
peer.
peer { group-name | ipv6-address }
as-number as-number
By default, no BGP peer is
configured.