HP MSR2000/3000/4000 Router Series MPLS Configuration Guide

234
1. Configure the MCE:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter BGP-VPN view.
ip vpn-instance
vpn-instance-name
N/A
4. Specify an IPv6 BGP peer in an
AS.
peer { group-name |
ipv6-address } as-number
as-number
By default, no BGP peer is
configured.
5. Enter BGP-VPN IPv6 unicast
address family view.
address-family ipv6 [ unicast ] N/A
6. Enable BGP to exchange IPv6
unicast routes with the specified
peer.
peer { group-name | ip-address }
enable
By default, BGP does not
exchange IPv6 unicast routes with
any peer.
7. Redistribute remote site routes
advertised by the PE.
import-route protocol
[ process-id [ med med-value |
route-policy route-policy-name ]
* ]
By default, no route redistribution
is configured.
8. (Optional.) Configure filtering of
advertised routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
export [ protocol process-id ]
By default, BGP does not filter
advertised routes.
9. (Optional.) Configure filtering of
received routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
import
By default, BGP does not filter
received routes.
2. Configure a VPN site:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Configure the MCE as an EBGP
peer.
peer { group-name |
ipv6-address } as-number
as-number
By default, no BGP peer is
configured.
4. Enter BGP IPv6 unicast address
family view.
address-family ipv6 [ unicast ] N/A
5. Enable BGP to exchange IPv6
unicast routes with the specified
peer.
peer { group-name | ip-address }
enable
By default, BGP does not
exchange IPv6 unicast routes with
any peer.
6. Redistribute the IGP routes of the
VPN.
import-route protocol
[ process-id [ med med-value |
route-policy route-policy-name ]
* ]
By default, no routes are
redistributed into BGP.
A VPN site must advertise IPv6
VPN network addresses it can
reach to the connected MCE.