4000 Router Series Security Configuration Guide

313

a. Select User Access Manager > Portal Service > IP Group from the navigation tree to enter the

portal IP address group configuration page.

b. Click Add to enter the page shown in Figure 90.

c. Enter the IP group name.

d. Enter the start IP address and end IP add

ress of the IP group.

Make sure the host IP address is in the IP group.

e. Select a service group.

This example uses the default group Ungrouped.

f. Select the IP group type Normal.

g. Click OK.

Figure 90 Adding an IP address group

3. Add a portal device:

a. Select User Access Manager > Portal Service > Device from the navigation tree to enter the

portal device configuration page.

b. Click Add to enter the page shown in Figure 91.

c. Enter the device name NA

d. Enter the IP address of the router's interface connected to the host.

e. Enter the key, which must be the same as that configured on the router.

f. Set whether to enable IP address reallocation.

This example uses direct portal authentication, and therefore select No from the Reallocate IP

list.

g. Select whether to support sever heartbeat and user heartbeat functions.

In this example, select No for both Support Server Heartbeat and Support User Heartbeat.

h. Click OK.