R0106-HP MSR Router Series ACL and QoS Command Reference(V7)

92
Parameters
interface-type interface-number: Specifies an interface by its type and number. If no interface is specified,
this command displays the WFQ configuration and statistics for all interfaces.
pvc { pvc-name | vpi/vci }: Specifies a PVC by its name or VPI/VCI value. You can specify a PVC only
for an ATM interface. When you specify an ATM interface but do not specify a PVC, the command
displays the WFQ configuration and statistics for all PVCs on the ATM interface.
Examples
# Display the WFQ configuration and statistics for GigabitEthernet 2/1/0.
<Sysname> display qos queue wfq interface gigabitethernet 2/1/0
Interface: GigabitEthernet2/1/0
Output queue - Urgent queuing: Size/Length/Discards 0/100/0
Output queue - Protocol queuing: Size/Length/Discards 0/500/0
Output queue - Weighted Fair queuing: Size/Length/Discards 0/64/0
Weight: IP Precedence
Queues: Active/Max active/Total 0/0/128
Table 31 Command output
Field Descri
p
tion
Interface Interface type and interface number.
Output queue Information about the current output queue.
Size Number of packets in the queue.
Length Queue length.
Discards Number of dropped packets.
Weight Weight type: IP precedence or DSCP.
Queues Queue information.
Active Number of active WFQ queues.
Max active Maximum number of active WFQ queues that was reached.
Total Total number of configured WFQ queues.
qos wfq
Use qos wfq to apply WFQ to an interface or PVC. You can also use this command to modify WFQ
parameters.
Use undo qos wfq to restore the default.
Syntax
qos wfq [ dscp | precedence ] [ queue-number total-queue-number | queue-length max-queue-length ]
*
undo qos wfq
Default
FIFO is used.