R0106-HP MSR Router Series High Availability Command Reference(V7)

23
Parameters
vid vlan-id: Specifies an IPv4 VRRP control VLAN (outer VLAN) by its VLAN ID in the range of 1 to 4094.
secondary-dot1q secondary-vlan-id: Specifies an inner VLAN by its VLAN ID in the range of 1 to 4094.
Usage guidelines
If you execute this command multiple times, the most recent configuration takes effect.
This command takes effect on only Layer 3 Ethernet subinterfaces and Layer 3 aggregate subinterfaces.
Examples
# Specify outer VLAN 2 as the IPv4 VRRP control VLAN and inner VLAN 100 for the IPv4 VRRP control
VLAN.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1.2
[Sysname-GigabitEthernet2/0/1.2] vrrp dot1q vid 2 secondary-dot1q 100
vrrp dscp
Use vrrp dscp to configure a DSCP value for VRRP packets.
Use undo vrrp dscp to restore the default.
Syntax
vrrp dscp dscp-value
undo vrrp dscp
Views
System view
Predefined user roles
network-admin
Parameters
dscp-value: Specifies a DSCP value for VRRP packets, in the range of 0 to 63. The default is 48.
Usage guidelines
The DSCP value identifies the packet priority during transmission. A greater DSCP value means a higher
packet priority.
Examples
# Configure the DSCP value for VRRP packets as 30.
<Sysname> system-view
[Sysname] vrrp dscp 30
vrrp mode
Use vrrp mode to specify the operating mode for IPv4 VRRP.
Use undo vrrp mode to restore the default.
Syntax
vrrp mode load-balance