R0106-HP MSR Router Series High Availability Command Reference(V7)

28
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] vrrp vrid 1 priority 150
Related commands
• display vrrp
• vrrp vrid track
vrrp vrid shutdown
Use vrrp vrid shutdown to disable an IPv4 VRRP group.
Use undo vrrp vrid shutdown to restore the default.
Syntax
vrrp vrid virtual-router-id shutdown
undo vrrp vrid virtual-router-id shutdown
Default
An IPv4 VRRP group is enabled.
Views
Interface view
Predefined user roles
network-admin
Parameters
virtual-router-id: Specifies an IPv4 VRRP group by its virtual router ID in the range of 1 to 255.
Usage guidelines
You can use this command to temporarily disable an IPv4 VRRP group. After this command is configured,
the VRRP group stays in initialized state, and its configurations remain unchanged. You can change its
configuration and your changes take effect when you enable the VRRP group again.
Examples
# Disable IPv4 VRRP group 1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] vrrp vrid 1 shutdown
vrrp vrid source-interface
Use vrrp vrid source-interface to specify the source interface for an IPv4 VRRP group. This interface,
instead of the interface where the VRRP group resides, sends and receives VRRP packets.
Use undo vrrp source-interface to cancel the specified source interface.
Syntax
vrrp vrid virtual-router-id source-interface interface-type interface-number
undo vrrp vrid virtual-router-id source-interface