R0106-HP MSR Router Series Interface Command Reference(V7)

163
Field Descri
p
tion
Framing Bit Err Framing bit error.
Severely Err Framing Secs Severely erroneous second.
C-bit Err Secs C-bit erroneous second.
C-bit Severely Err Secs C-bit severely erroneous second.
P-bit Err Secs P-bit erroneous second.
P-bit Severely Err Secs P-bit severely erroneous second.
Unavailable Secs Service unavailable second.
Line Err Secs
Line erroneous second, during which LOS, BPV, EXZ, C-bit, P-bit,
and other errors occur.
Data in Interval 1: Statistics spanning interval 1.
Total Data (last 17 15 minute intervals) Total data spanning the last 17 intervals.
T3 2/4/0 CT1 1 is up
State of T1 line on the CT3 interface: up or down. In this output
sample, T1 line 1 is up.
Frame-format ESF, clock slave,
loopback not set
Information about the T1 line:
• Framing format—ESF or SF.
• Clock source—Slave for the line clock and master for the internal
clock.
• Loopback—Local, remote, payload, or not set.
FDL Performance Report is disabled
Transmission of PPR in the FDL is disabled. You can enable it by
using the t1 set fdl ansi command.
Transmitter is sending RAI
The transmitter of the T1 line is sending RAI signals. When the T1 line
receives LOS, LOF, or AIS signals, it sends RAI signals.
Receiver alarm state is LOF
Type of alarm signal that the T1 line can receive: LOS, LOF, AIS, or
RAI.
Line loop back activate code using
inband signal last sent
The loopback code sent last time is in-band LLB activation request
code.
Related commands
reset counters controller t3
feac
Use feac to enable far end and control signal (FEAC) channel signal detection and transmission on a
CT3 interface.
Use undo feac to remove the current FEAC settings.
Syntax
feac { detect | generate { ds3-los | ds3-ais | ds3-oof | ds3-idle | ds3-eqptfail | loopback { ds3-line |
ds3-payload } } }
undo feac { detect | generate { ds3-los | ds3-ais | ds3-oof | ds3-idle | ds3-eqptfail | loopback
{ ds3-line | ds3-payload } } }