R0106-HP MSR Router Series Interface Command Reference(V7)

227
Field Descri
p
tion
Last clearing of counters: Never
Time when the reset counters interface command was last used
to clear the interface statistics.
Never indicates the reset counters interface command has
never been used on the interface after the device has started up.
Last 300 seconds input rate: 0.00 bytes/sec,
0.00 packets/sec
Average input rate over the last 300 seconds.
• bytes/sec—Average bytes input every second.
• packets/sec—Average packets input every second.
Last 300 seconds output rate: 0.00
bytes/sec, 0.00 packets/sec
Average output rate over the last 300 seconds.
• bytes/sec—Average bytes output every second.
• packets/sec—Average packets output every second.
Input:
0 packets, 0 bytes, 0 buffers
0 errors, 0 crcs, 0 lens, 0 giants
0 pads, 0 aborts, 0 timeouts
0 overflows, 0 overruns, 0 no buffer
Packet input parameters:
• packets—Number of total packets received.
• bytes—Number of total bytes received.
• buffers—Number of buffers used to receive packets.
• errors—Number of errored packets detected in the physical
layer.
• crcs—Number of CRC errors.
• lens—Number of packets received in invalid lengths.
• giants—Number of packets received in lengths exceeding
the set value.
• pads—Number of errors occurred in the packet padding
process.
• aborts—Number of abnormal errors.
• timeouts—Number of timeout packets.
• overflows—Number of chip FIFO overflow errors occurred
in the receiving process.
• overruns—Number of packets unprocessed due to high
receiving rates exceeding the forwarding rate.
• no buffer—Number of errors caused by insufficient system
resources.
Output:
0 packets, 0 bytes, 0 buffers
0 errors, 0 overflows, 0 underruns
Packet output parameters:
• packets—Number of total packets transmitted.
• bytes—Number of total bytes transmitted.
• buffers—Number of buffers used to transmit packets.
• errors—Number of errored packets detected in the physical
layer.
• overflows—Number of chip FIFO overflow errors occurred
in the transmitting process.
• underruns—Number of packets untransmitted because the
interface reading rate was lower than the forwarding rate.
Brief information on interface(s) under route
mode
Brief information about the layer 3 interface.