R0106-HP MSR Router Series Interface Command Reference(V7)

255
Examples
# Set the SNR margin to 5 for interface ATM 1/0.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-ATM1/0] shdsl snr-margin current 5
shdsl wire
Use shdsl wire to set the wire mode for a four-wire SHDSL interface or an eight-wire SHDSL interface.
Use undo shdsl wire to restore the default.
Syntax
In ATM SHDSL_4WIRE interface view:
shdsl wire { 2 | 4-auto-enhanced | 4-enhanced | 4-standard }
undo shdsl wire
In ATM SHDSL_8WIRE_BIS interface view:
shdsl wire { 2 | 4-enhanced | 4-standard | 6 | 8 | auto }
undo shdsl wire
Default
An ATM SHDSL_4WIRE interface operates in the four-wire enhanced mode.
An ATM SHDSL_8WIRE_BIS interface operates in the eight-wire mode.
Views
ATM SHDSL_4WIRE interface view, ATM SHDSL_8WIRE_BIS interface view
Predefined user roles
network-admin
Parameters
2: Specifies the two-wire mode.
4-auto-enhanced: Specifies the four-wire automatic mode. The four-wire enhanced mode is used first
when the local end negotiates with the remote end. If the remote end is not operating in four-wire
enhanced mode, the local end uses the four-wire standard mode for negotiation.
4-enhanced: Specifies the four-wire enhanced mode. In this mode, one pair of the four wires starts
negotiation with the remote end first. Then the other pair starts negotiation with the remote end.
4-standard: Specifies the four-wire standard mode. In this mode, the two pairs of these four wires must
start negotiation at the same time. In addition, the remote end must be set to operate in four-wire
standard mode as well.
6: Specifies the six-wire mode.
8: Specifies the eight-wire mode.
auto: Specifies the automatic mode. The local end uses the operating mode of the remote end to
negotiate with the remote end.