R0106-HP MSR Router Series Interface Command Reference(V7)

26
Packets dropped due to full GBP or insufficient bandwidth: 301
Packets dropped due to Fast Filter Processor FFP: 261
Packets dropped due to STP non-forwarding state: 321
Packets dropped due to rate-limit: 143
Packets dropped due to broadcast-suppression: 301
Packets dropped due to unicast-suppression: 215
Packets dropped due to multicast-suppression: 241
Packets dropped due to Tx packet aging: 246
# Display the summary of dropped packets on all interfaces.
<Sysname> display packet-drop summary
All interfaces:
Packets dropped due to full GBP or insufficient bandwidth: 301
Packets dropped due to FFP: 261
Packets dropped due to STP non-forwarding state: 321
Packets dropped due to rate-limit: 143
Packets dropped due to broadcast-suppression: 301
Packets dropped due to unicast-suppression: 215
Packets dropped due to multicast-suppression: 241
Packets dropped due to Tx packet aging: 246
Table 6 Command output
Field Description
Packets dropped due to full GBP or insufficient
bandwidth
Packets that are dropped because the buffer is used
up or the bandwidth is insufficient.
Packets dropped due to Fast Filter Processor FFP Packets that are filtered out.
Packets dropped due to STP non-forwarding state
Packets that are dropped because STP is in the
non-forwarding state.
Packets dropped due to rate-limit
Packets that are dropped due to the rate limit set on
the device.
Packets dropped due to broadcast-suppression
Packets that are dropped due to broadcast
suppression.
Packets dropped due to unicast-suppression
Packets that are dropped due to unknown unicast
suppression.
Packets dropped due to multicast-suppression
Packets that are dropped due to multicast
suppression.
Packets dropped due to Tx packet aging Outbound packets that are timed out.
duplex
Use duplex to set the duplex mode for an Ethernet interface.
Use undo duplex to restore the default duplex mode of the Ethernet interface.
Syntax
duplex { auto | full | half }
undo duplex