R0106-HP MSR Router Series Interface Command Reference(V7)

75
Field Description
Link
Physical link state of the interface:
• UP—The physical link of the interface is up.
• DOWN—The physical link of the interface is down.
• ADM—The interface has been administratively shut down. To
bring up the interface, use the undo shutdown command.
• Stby—The interface is operating as a backup interface.
Protocol
Data link layer state of the interface:
• UP—The data link layer of the interface is up.
• DOWN—The data link layer of the interface is down.
• UP(s)—The data link layer of the interface is spoofing up. This
state is available for on-demand link setup applications. This
state enables the device to initiate an on-demand link setup
when a link is not present.
Main IP Main IP address of the interface.
Description Description of the interface.
Cause
Cause of a DOWN physical link. If the port has been shut down
by using the shutdown command, this field displays
Administratively. To restore the physical state of the interface, use
the undo shutdown command. Not connected means there is no
physical connection (no cable is available or the cable is faulty).
Related commands
reset counters interface
eliminate-pulse
Use eliminate-pulse to eliminate the pulses with a width less than 3.472 μs to increase signal reliability.
Use undo eliminate-pulse to restore the default.
Syntax
eliminate-pulse
undo eliminate-pulse
Default
The pulses with a width less than 1.472 μs are eliminated.
Views
AM interface view
Predefined user roles
network-admin
Usage guidelines
When the baud rate of the interface is 115200 bps, you cannot configure this command. After you
configure this command, the baud rate of the interface cannot be set to 115200 bps.
This command applies to 8ASE and 16ASE interface cards.