R0106-HP MSR Router Series Interface Command Reference(V7)

86
Default
RAI detection is enabled on an interface.
Views
CE1/PRI interface view
Predefined user roles
network-admin
Parameters
rai: Remote Alarm Indication (RAI).
Usage guidelines
This command is applicable when the interface operates in CE1 mode.
Examples
# Enable RAI detection on E1 2/3/0.
<Sysname> system-view
[Sysname] controller e1 2/3/0
[Sysname-E1 2/3/0] alarm-detect rai
cable (CE1/PRI interface)
Use cable to set the cable type for a CE1/PRI interface.
Use undo cable to restore the default.
Syntax
cable { long | short }
undo cable
Default
The long keyword applies.
Views
CE1/PRI interface view
Predefined user roles
network-admin
Parameters
long: Specifies the attenuation of the receiver as –43 dB.
short: Specifies the attenuation of the receiver as –10 dB.
Examples
# Set the cable length matching E1 2/3/0 to short.
<Sysname> system-view
[Sysname] controller e1 2/3/0
[Sysname-E1 2/3/0] cable short