R0106-HP MSR Router Series IP Multicast Command Reference(V7)

286
• state-refresh-interval (IPv6 PIM view)
• state-refresh-rate-limit (IPv6 PIM view)
ipv6 pim timer graft-retry
Use ipv6 pim timer graft-retry to set the graft retry timer.
Use undo ipv6 pim timer graft-retry to restore the default.
Syntax
ipv6 pim timer graft-retry interval
undo ipv6 pim timer graft-retry
Default
The graft retry timer is 3 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
interval: Specifies a graft retry timer in the range of 1 to 65535 seconds.
Examples
# Set the graft retry timer to 80 seconds on GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] ipv6 pim timer graft-retry 80
ipv6 pim timer hello
Use ipv6 pim timer hello to set the interval for sending hello messages on an interface.
Use undo ipv6 pim timer hello to restore the default.
Syntax
ipv6 pim timer hello interval
undo ipv6 pim timer hello
Default
The hello interval is 30 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
interval: Sets the interval for sending hello messages, in the range of 0 to 18000 seconds. If you set the
value to 0, no hello messages are sent.