R0106-HP MSR Router Series Layer 2 - LAN Switching Configuration Guide(V7)

23
• When an aggregate interface is brought up, the aggregation state of ports in the corresponding
aggregation group is recalculated.
To shut down an aggregate interface:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 3 aggregate
interface or subinterface view.
interface route-aggregation
{ interface-number |
interface-number.subnumber }
N/A
3. Shut down the aggregate
interface or subinterface.
shutdown
By default, all aggregate interfaces
are up.
Restoring the default settings for an aggregate interface
You can return all configurations on an aggregate interface to default settings.
To restore the default settings for an aggregate interface:
Step Command
1. Enter system view.
system-view
2. Enter Layer 3 aggregate interface or
subinterface view.
interface route-aggregation { interface-number |
interface-number.subnumber }
3. Restore the default settings for the
aggregate interface.
default
Configuring load sharing for link aggregation
groups
You can configure global or group-specific load sharing criteria. A link aggregation group preferentially
uses the group-specific load sharing criteria. If no group-specific load sharing criteria is available, the
group uses the global load sharing criteria.
Configuring the global link-aggregation load sharing criteria
Step Command
1. Enter system view.
system-view
2. Configure the global link-aggregation
load sharing criteria.
link-aggregation global load-sharing mode { destination-ip |
destination-port | source-ip | source-port }