R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

171
Field Descri
p
tion
Last clearing of counters: Never
Time when the reset counters interface command was last used to clear
the interface statistics. Never indicates the reset counters interface
command has never been used on the interface after the device has
started up.
Last 300 seconds input rate Average packet input rate over the last 300 seconds.
Last 300 seconds output rate Average packet output rate over the last 300 seconds.
Input
Input packet statistics:
• packets—Number of packets.
• bytes—Total bytes.
• drops—Number of dropped packets.
Output
Output packet statistics:
• packets—Number of packets.
• bytes—Total bytes.
• drops—Number of dropped packets.
Brief information on interface(s)
under route mode
Brief information about the Layer-3 interface.
Link: ADM - administratively down;
Stby - standby
Link layer state of the interface:
• ADM—The interface was shut down by the network administrator. To
recover its physical layer state, use the undo shutdown command.
• Stby—The interface is a standby interface. You can use the display
interface-backup state command to check the corresponding primary
interface.
Protocol: (s) - spoofing
If the protocol attribute of an interface includes the spoofing flag (an s in
parentheses), the data link layer protocol state of the interface is shown as
UP, but its link is an on-demand link or not present at all.
Interface Abbreviation of the interface name.
Link
Physical connection state of the interface:
• UP—The interface is physically up.
• ADM—The interface is shut down manually. You can bring up the
interface with command undo shutdown.
• Stby—The interface is a standby interface.
Protocol
Data link layer protocol state:
• UP—The data link layer is up.
• DOWN—The data link layer is down.
• UP(s)—The data link layer protocol state of the interface is up, but its
link is an on-demand link or not present at all.
Main IP Primary IP address of the interface.
Description
Description for the interface configured with command description. The
display interface brief command displays the first 27 characters when
you do not specify the description keyword, and displays the entire
description when you specify the description keyword.