R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

25
Brief information on interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
MP1 ADM Administratively
MP12 DOWN Not connected
Table 3 Command output
Field Descri
p
tion
MP-group12
Current state
Physical and administrative states of the interface:
• DOWN (Administratively)—The interface was administratively
shut down with the shutdown command.
• DOWN—The interface is administratively up but physically down
(possibly because no physical link is present or the link is faulty).
• UP—The interface is both administratively and physically up.
Line protocol state Data link layer state: UP or DOWN.
Description Interface description.
Bandwidth Expected bandwidth of the interface.
Hold timer Interval at which the interface sends keepalive packets.
Internet protocol processing Network layer state: enabled or disabled.
LCP initial LCP negotiation is complete.
Physical Physical type of the interface.
Output queue - Urgent queuing:
Size/Length/Discards 0/100/0
Output queue - Protocol queuing:
Size/Length/Discards 0/500/0
Output queue - FIFO queuing:
Size/Length/Discards 0/75/0
Traffic statistics of the interface output queues.
Last clearing of counters: Never
Last time when statistics on the interface were cleared. Never
indicates that statistics on the interface were never cleared.
Last 300 seconds input rate: 0
bytes/sec, 0 packets/sec
Last 300 seconds output rate: 0
bytes/sec, 0 packets/sec
Average rate of input packets and output packets in the last 300
seconds.
Input: 0 packets, 0 bytes, 0 droped
Total number of inbound packets of the interface (in the number of
packets and in bytes), and the number of dropped incoming packets.
Output: 0 packets, 0 bytes, 0 droped
Total number of outbound packets of the interface (in the number of
packets and in bytes), and the number of dropped outgoing packets.
Brief information on interface(s) under
route mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, execute the undo shutdown command.
• Stby—The interface is operating as a backup interface. To see the
primary interface, use the display interface-backup state
command in High Availability Command Reference.