R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

119
Table 5 Encapsulation type support for ATM applications
ATM application aal5snap aal5mux aal5nlpid
IPoA Supported
Supported (InARPoA not
supported)
Supported (InARPoA not
supported)
IPoEoA Supported Supported Not supported
PPPoA Supported Supported Not supported
PPPoEoA Supported Supported Not supported
NOTE:
W
ith aal5snap used, two or more protocols are supported. But with aal5nlpid, only one protocol is
supported.
Configuring a VE interface
Before you configure IPoEoA and PPPoEoA, you must specify a VE interface.
To configure a VE interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a VE interface
and enter VE
interface view.
interface virtual-ethernet
interface-number
If the interface already exists, use this
command to enter the VE interface view.
You can create a maximum of 1024 VE
interfaces.
3. Configure the
description for the
interface.
description text
By default, the description is in the format of
interface-name Interface, for example,
Virtual-Ethernet 0 Interface.
4. Configure the MTU
for the interface.
mtu size
By default, the MTU for the interface is 1500
bytes.
5. Configure the MAC
address for the
interface.
mac-address mac-address
By default, the VE interface uses the bridge
MAC address as its MAC address.
6. Configure the
expected bandwidth
for the interface.
bandwidth bandwidth-value
By default, the expected bandwidth (in kbps)
is the interface baud rate divided by 1000.
7. Restore the default
settings for the
interface.
default N/A
8. Shut down the
interface.
shutdown By default, the interface is up.
To configure a VE subinterface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A