R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)
9
1. If the AAA server assigns an IP address to the client or has a specified address pool, the server
assigns that IP address or an IP address from the specified address pool to the client. The IP
address or address pool is configured on the AAA server instead of the PPP server.
2. If an address pool is associated with the ISP domain used during client authentication, the server
assigns an IP address from the associated address pool to the client.
3. If an IP address or address pool is specified for the client on the interface of the server, the server
assigns that IP address or an IP address from that address pool to the client.
To configure the device as the client:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable IP address
negotiation.
ip address ppp-negotiate
By default, IP address negotiation
is not enabled.
This command is mutually
exclusive with the ip address
command. For more information
about the ip address command,
see Layer 3—IP Services
Command Reference.
Configure the server to assign an IP address to a client by using the following methods:
• Method 1: Specify an IP address for the client on the server interface.
• Method 2: Specify an address pool on the server interface.
• Method 3: Use the address pool associated with the ISP domain.
For clients requiring no authentication, you can use either method 1 or method 2, but not both.
For clients requiring authentication, you can use one or more of the three methods, but cannot use
method 1 and method 2 at the same time. When multiple methods are configured, method 3 takes
precedence over method 1 or method 2.
To configure the device as the server (Method 1):
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the interface to assign
an IP address to the peer.
remote address ip-address
By default, an interface does not
assign an IP address to the peer.
4. Configure an IP address for the
interface.
ip address ip-address
By default, no IP address is
configured on an interface.
To configure the device as the server (Method 2):
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A