R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

206
[RouterA-Serial2/1/0] quit
# Configure RIP.
[RouterA] rip
[RouterA-rip-1] network 10.0.0.0
[RouterA-rip-1] network 20.0.0.0
[RouterA-rip-1] import-route direct
[RouterA-rip-1] quit
# Configure the routes used by the serial interface to adopt higher priorities than those used by the
dialup interface.
[RouterA] interface bri 2/4/0
[RouterA-Bri2/4/0] rip metricin 2
2. Configure Router B:
# Create dialer group 1 and configure a dial rule for it. Create a local user usera for Router A, and
configure PPP authentication for the user.
<RouterB> system-view
[RouterB] dialer-group 1 rule ip permit
[RouterB] local-user usera class network
[RouterB-luser-network-usera] password simple usera
[RouterB-luser-network-usera] service-type ppp
[RouterB-luser-network-usera] quit
# Configure bundle DDR on interface Dialer 0.
[RouterB] interface dialer 0
[RouterB-Dialer0] link-protocol ppp
[RouterB-Dialer0] ip address 20.0.0.2 24
[RouterB-Dialer0] dialer bundle enable
[RouterB-Dialer0] dialer peer-name usera
[RouterB-Dialer0] dialer-group 1
[RouterB-Dialer0] dialer number 8810010
[RouterB-Dialer0] ppp authentication-mode pap
[RouterB-Dialer0] ppp pap local-user userb password simple userb
[RouterB-Dialer0] quit
# Configure dialup parameters for interface BRI 2/4/0.
[RouterB] interface bri 2/4/0
[RouterB-Bri2/4/0] dialer bundle-member 0
[RouterB-Bri2/4/0] ppp authentication-mode pap
[RouterB-Bri2/4/0] ppp pap local-user userb password simple userb
[RouterB-Bri2/4/0] quit
# Enable PPP on interface Serial 2/1/0.
[RouterB] interface serial 2/1/0
[RouterB-Serial2/1/0] link-protocol ppp
[RouterB-Serial2/1/0] ip address 10.0.0.2 8
[RouterB-Serial2/1/0] quit
# Configure interface Loopback 1.
[RouterB] interface loopback 1
[RouterB-Loopback1] ip address 30.0.0.1 32
[RouterB-Loopback1] quit
# Configure RIP.