R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

17
Ste
p
Command Remarks
10. Associate a physical interface or
a username to the VT interface.
• (Method 1) Bind a physical
interface to the VT interface:
a. Enter interface view:
interface interface-type
interface-number
b. Bind the interface to the
specified VT interface, and
enable MP for the interface:
ppp mp virtual-template
number
c. (Optional.) Configure PPP
authentication (see
"Configuring PPP
au
the
ntication.")
• (Method 2) Associate a username
to the VT interface:
d. Associate a VT interface to a
username:
ppp mp user username bind
virtual-template number
e. Enter interface view:
interface interface-type
interface-number
f. Enable MP for the interface:
ppp mp
g. Configure PPP authentication
(see "Configuring PPP
au
the
ntication.")
By default, a physical
interface is enabled with PPP
and not bound to any VT
interfaces.
PPP authentication does not
affect MP when Method 1 is
used.
By default, a VT interface is
not bound to any usernames.
11. Configure other MP parameters.
See "Configuring other optional
parameters."
N/A
Configuring other optional parameters
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MP VT interface or dialer
interface view.
interface { dialer | virtual-template }
number
For more information about
configuring MP parameters in
dialer interface view, see
"Configuring DDR."
3. Set the binding mode.
ppp mp binding-mode
{ authentication | both | descriptor }
By default, both the username
and the descriptor are used for
MP binding.
4. (Optional.) Set the maximum
number of links in an MP
bundle.
ppp mp max-bind max-bind-num
The default setting is 16.
To apply the new setting, you
must re-enable all the physical
interfaces in the MP bundle by
executing the shutdown
command and then the undo
shutdown command.