R0106-HP MSR Router Series MPLS Command Reference(V7)

134
On the same tunnel interface, the mpls te reoptimization command cannot be used together with these
commands: mpls te auto-bandwidth adjustment, mpls te route-pinning, mpls te backup, and mpls te
resv-style ff.
Examples
# Enable reoptimization for tunnel 0, and set the reoptimization frequency to 43200 seconds (12 hours).
<Sysname> system-view
[Sysname] interface tunnel 0 mode mpls-te
[Sysname-Tunnel0] mpls te reoptimization frequency 43200
Related commands
• display mpls te tunnel-interface
• mpls te reoptimization (user view)
mpls te reoptimization (user view)
Use mpls te reoptimization to reoptimize all reoptimization-enabled MPLS TE tunnels.
Syntax
mpls te reoptimization
Views
User view
Predefined user roles
network-admin
Usage guidelines
After reoptimization is enabled for a tunnel by using the mpls te reoptimization command in tunnel
interface view, you can use this command in user view to trigger the ingress node to immediately reselect
an optimal path for the tunnel.
Examples
# Reoptimize all reoptimization-enabled MPLS TE tunnels.
<Sysname> mpls te reoptimization
Related commands
mpls te reoptimization (tunnel interface view)
mpls te resv-style
Use mpls te resv-style to configure the resource reservation style for the MPLS TE tunnel.
Use undo mpls te resv-style to restore the default.
Syntax
mpls te resv-style { ff | se }
undo mpls te resv-style
Default
The resource reservation style is SE.