R0106-HP MSR Router Series MPLS Command Reference(V7)

150
bandwidth: Specifies the CT and required bandwidth for the static CRLSP. If you do not specify this
keyword, the bandwidth required by the static CRLSP is 0 kbps. If you specify this keyword but do not
specify a CT, the static CRLSP belongs to CT 0.
ct0: Specifies CT 0 for the static CRLSP.
ct1: Specifies CT 1 for the static CRLSP.
ct2: Specifies CT 2 for the static CRLSP.
ct3: Specifies CT 3 for the static CRLSP.
bandwidth-value: Specifies the bandwidth required by the static CRLSP, in the range of 1 to 4294967295
kbps. The default is 0 kbps.
Usage guidelines
The next hop address specified for the static CRLSP cannot be a public IP address on the local device.
CT 2 and CT 3 are valid only in IETF DS-TE mode. In prestandard DS-TE mode, CT 2 and CT 3 are invalid
and the tunnel cannot be established.
Examples
# Configure a static CRLSP on the ingress node, and configure its name as static-te-2, next hop IP
address as 202.55.25.33, outgoing label as 237, CT as CT 0, and required bandwidth as 20 kbps.
<Sysname> system-view
[Sysname] static-cr-lsp ingress static-te-2 nexthop 202.55.25.33 out-label 237 bandwidth
ct0 20
Related commands
• display mpls static-cr-lsp
• static-cr-lsp egress
• static-cr-lsp transit
static-cr-lsp transit
Use static-cr-lsp transit to configure a transit node for a static CRLSP.
Use undo static-cr-lsp transit to delete the transit node configuration of the static CRLSP.
Syntax
static-cr-lsp transit lsp-name in-label in-label-value { nexthop next-hop-addr | outgoing-interface
interface-type interface-number } out-label out-label-value [ bandwidth [ ct0 | ct1 | ct2 | ct3 ]
bandwidth-value ]
undo static-cr-lsp transit lsp-name
Default
No static CRLSP exists on the device.
Views
System view
Predefined user roles
network-admin