R0106-HP MSR Router Series Network Management and Monitoring Command Reference(V7)

377
Examples
# O u t p u t l o g s t o t h e l o g h o s t 1.1.1.1.
<Sysname> system-view
[Sysname] info-center loghost 1.1.1.1
info-center loghost source
Use info-center loghost source to specify the source IP address for output logs.
Use undo info-center loghost source to restore the default.
Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
Default
The source IP address of output logs is the primary IP address of the matching route's egress interface.
Views
System view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies the egress interface for logs.
Usage guidelines
The system uses the primary IP address of the specified egress interface as the source IP address of log
information no matter which physical interface is used to output the logs.
The info-center loghost source command takes effect only after the information center is enabled with the
info-center enable command.
Examples
# Specify the IP address of interface loopback 0 as the source IP address of logs.
<Sysname> system-view
[Sysname] interface loopback 0
[Sysname-LoopBack0] ip address 2.2.2.2 32
[Sysname-LoopBack0] quit
[Sysname] info-center loghost source loopback 0
info-center security-logfile alarm-threshold
Use info-center security-logfile alarm-threshold to set the alarm threshold for security log file usage.
Use undo info-center security-logfile alarm-threshold to restore the default.
Syntax
info-center security-logfile alarm-threshold usage
undo info-center security-logfile alarm-threshold