R0106-HP MSR Router Series Security Command Reference(V7)

479
reset session relation-table
Use reset session relation-table to clear relation entries.
Syntax
MSR2000/MSR3000:
reset session relation-table [ ipv4 | ipv6 ]
MSR4000:
reset session relation-table [ ipv4 | ipv6 ] [ slot slot-number ]
Views
User view
Predefined user roles
network-admin
Parameters
ipv4: Specifies IPv4 relation entries.
ipv6: Specifies IPv6 relation entries.
slot slot-number: Specifies a card by its slot number. If no card is specified, this command clears the
relation entries on all cards. (MSR4000.)
Usage guidelines
If neither the IPv4 keyword nor the IPv6 keyword is specified, this command clears all IPv4 and IPv6
relation entries.
Examples
# Clear all IPv4 relation entries.
<Sysname> reset session relation-table ipv4
Related commands
display session relation-table
session aging-time application
Use session aging-time application to set the aging time for sessions of an application layer protocol.
Use undo session aging-time application to restore the default. If no application layer protocol is
specified, this command restores the default aging time for all sessions of the supported application layer
protocols.
Syntax
session aging-time application { dns | ftp | gtp | h225 | h245 | ils | mgcp | nbt | pptp | ras | rsh |
rtsp | sccp | sip | sqlnet | tftp | xdmcp } time-value
undo session aging-time application [ dns | ftp | gtp | h225 | h245 | ras | rtsp | sip | tftp ]
Default
The aging time for sessions of application layer protocols is as follows:
• DNS sessions: 60 seconds.
• FTP sessions: 3600 seconds.