4000 Router Series Network Management and Monitoring Command Reference

190

undo mirroring-group group-id monitor-port

Default

No monitor port is configured for a mirroring group.

Views

Interface view

Predefined user roles

network-admin

Parameters

group-id: Specifies the number of a mirroring group. The mirroring group specified by group-id must

already exist. The value range for this argument varies with device models.

The following matrix shows the value ranges for the group-id argument:

MSR2000 MSR3000 MSR4000

Always 1 1 to 6 1 to 6

Usage guidelines

You can configure the monitor port only for a local mirroring group.

Use a monitor port only for port mirroring to make sure the data monitoring device receives and analyzes

only the mirrored traffic rather than a mix of mirrored traffic and correctly forwarded traffic.

Do not configure a port of an existing mirroring group as a monitor port.

Examples

# Create local mirroring group 1, and configure port Ethernet 1/1 as its monitor port.

<Sysname> system-view

[Sysname] mirroring-group 1 local

[Sysname] interface ethernet 1/1

[Sysname-Ethernet1/1] mirroring-group 1 monitor-port

Related commands

mirroring-group

mirroring-group monitor-port (system view)

Use mirroring-group monitor-port to configure a port as the monitor port for a mirroring group.

Use undo mirroring-group monitor-port to remove the monitor port from a mirroring group.

Syntax

mirroring-group group-id monitor-port interface-type interface-number

undo mirroring-group group-id monitor-port interface-type interface-number

Default

No monitor port is configured for a mirroring group.

Views

System view