HP MSR2000/3000/4000 Router Series ACL and QoS Command Reference

67
Predefined user roles
network-admin
Parameters
For the description of the keywords, see Table 19.
Usage guidelines
The priority map applies to both inbound and outbound traffic.
Examples
# Enter the dot1p-lp priority map view.
<Sysname> system-view
[Sysname] qos map-table inbound dot1p-lp
[Sysname-maptbl-in-dot1p-lp]
Related commands
• display qos map-table
• import
Port priority commands
The command in this section is supported only on routers installed with Layer 2 Ethernet switching
modules. For information about interface modules, see HP MSR Router Series Interface Module Guide.
qos priority
Use qos priority to change the port priority of an interface.
Use undo qos priority to restore the default.
Syntax
qos priority priority-value
undo qos priority
Default
The port priority is 0.
Views
Interface view
Predefined user roles
network-admin
Parameters
priority-value: Specifies the port priority value in the range of 0 to 7
Examples
# Set the port priority of interface Ethernet 1/1 to 2.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] qos priority 2