HP MSR2000/3000/4000 Router Series ACL and QoS Configuration Guide

35
Ste
p
Command Remarks
5. Create a traffic
behavior and enter
traffic behavior view.
traffic behavior behavior-name
By default, no traffic behavior is
configured.
6. Configure a traffic
policing action.
car cir committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size ] ] [ pir
peak-information-rate ] [ green action |
red action | yellow action ] *
By default, no traffic policing action is
configured.
7. Return to system view.
quit N/A
8. Create a QoS policy
and enter QoS policy
view.
qos policy policy-name
By default, no QoS policy is
configured.
9. Associate the traffic
class with the traffic
behavior in the QoS
policy.
classifier classifier-name behavior
behavior-name
By default, a traffic class is not
associated with a traffic behavior.
10. Return to system view.
quit N/A
11. Apply the QoS policy
to the interface.
Applying the QoS policy to an
interfa
ce
By default, a QoS policy is not
applied.
12. (Optional.) Display
traffic policing
configuration.
display qos policy user-defined
[ policy-name ]
Available in any view.
Configuring traffic policing by using the non-MQC approach
Configuring CAR-list-based traffic policing
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure a CAR list.
qos carl carl-index { dscp dscp-list | mac
mac-address | mpls-exp mpls-exp-value |
precedence precedence-value |
{ destination-ip-address |
source-ip-address } { range start-ip-address to
end-ip-address | subnet ip-address
mask-length } [ per-address
[ shared-bandwidth ] ] }
By default, no CAR list is
configured.
3. Enter interface view.
interface interface-type interface-number N/A
4. Configure a
CAR-list-based CAR
policy on the interface.
qos car { inbound | outbound } carl
carl-index cir committed-information-rate [ cbs
committed-burst-size [ ebs excess-burst-size ] ]
[ pir peak-information-rate ] [ green action |
red action | yellow action ] *
By default, no CAR policy is
configured.