HP MSR2000/3000/4000 Router Series ACL and QoS Configuration Guide

38
Ste
p
Command Remarks
2. Enter interface view.
interface interface-type interface-number N/A
3. Configure GTS on the
interface.
qos gts any cir committed-information-rate
[ cbs committed-burst-size [ ebs
excess-burst-size ] ] [ queue-length
queue-length ]
By default, GTS is not configured
on an interface.
Configuring the rate limit
The rate limit of a physical interface specifies the maximum rate of incoming packets or outgoing packets.
To configure the rate limit:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number
N/A
3. Configure the rate limit
for the interface.
qos lr { inbound | outbound } cir
committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size ] ]
By default, rate limit is not
configured on an interface.
Displaying and maintaining traffic policing, GTS,
and rate limit
Execute display commands in any view.
Task Command
Display CAR configuration and statistics on
an interface.
display qos car interface [ interface-type interface-number ]
Display CAR list information. display qos carl [ carl-index ]
Display traffic behavior configuration. display qos policy user-defined [ policy-name ]
Display GTS configuration and statistics on
an interface.
display qos gts interface [ interface-type interface-number ]
Display rate limit configuration and statistics
on an interface.
display qos lr interface [ interface-type interface-number ]