HP MSR2000/3000/4000 Router Series Fundamentals Command Reference

246
4. In schedule view, use the job command to assign the job to the schedule. You can assign multiple
jobs to a schedule. The jobs must already exist.
5. In schedule view, use the time at, time once, or time repeating command to specify an execution
time for the schedule. You can specify only one execution time per schedule.
Examples
# Create a schedule named saveconfig.
<Sysname> system-view
[Sysname] scheduler schedule saveconfig
Related commands
• job
• time at
• time once
• time interval
shutdown-interval
Use shutdown-interval to set the detection timer.
Use undo shutdown-interval to restore the default.
Syntax
shutdown-interval time
undo shutdown-interval
Default
The detection interval is 30 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
time: Specifies a detection timer (in seconds) in the range of 1 to 300.
Usage guidelines
The device starts a detection timer when a port is shut down by a protocol. If the port is still down when
the detection timer expires, the device automatically brings up the port so the port status reflects the port's
actual physical status.
If you change the detection timer to T1 during port detection, the interval from when you change the timer
to the time when the protocol module shuts down the port is T. If T<T1, the down port will be recovered
after T1-T time. If T>=T1, the down port is recovered immediately. For example, if the detection timer is set
to 30 seconds and you change it to 10 seconds (T1=10) two seconds after the port is shut down (T=2),
this port will be recovered 8 seconds later. If the detection timer is set to 30 seconds and you change it
to 2 seconds ten seconds after the port is shut down, this port is recovered immediately.
Examples
# Set the detection timer to 100 seconds.