4000 Router Series Fundamentals Command Reference

Some login management commands are available in both user line view and user line class view. This

chapter describes only the login management commands available in user line view.

If you configure a login management command in user line view, the configuration is applied only to the

specified user lines. If you configure a login management command in user line class view, the

configuration is applied to all user lines of the class. The configuration in user line view takes precedence

over the configuration in user line class view. If a parameter is not configured in user line view or user line

class view, the factory default setting is used.

Some login management commands are not supported in some user line views but can be configured in

the corresponding user line class views. However, the commands do not take effect.

The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for features,

commands, and parameters might differ in FIPS mode and non-FIPS mode. For more information about

FIPS mode, see Security Configuration Guide.

activation-key

Use activation-key to define a shortcut key for starting a terminal session.

Use undo activation-key to restore the default.

Syntax

activation-key character

undo activation-key

Default

Pressing Enter starts a terminal session.

Views

User line view, user line class view

Predefined user roles

network-admin

Parameters

character: Specifies the shortcut key. It can be a single character, a key sequence, or the ASCII code

value (in the range of 0 to 127) of the character or key sequence.

Usage guidelines

This command is not supported in VTY line view or VTY line class view.

To display the shortcut key you have defined, use the display current-configuration | include

activation-key command.

Examples

# Configure character s as the shortcut key for starting a terminal session on the console line.

<Sysname> system-view

[Sysname] line console 0