HP MSR2000/3000/4000 Router Series Fundamentals Configuration Guide

47
Ste
p
Command Remarks
2. Enter console/AUX
line view or class view.
• To enter console/AUX line
view:
line { aux | console }
first-number [ last-number ]
• To enter console/AUX line
class view:
line class { aux | console }
Use either command.
Settings configured in a user line class view
are applied as user-defined default settings
to all user lines of the line class. Settings
configured in a user line view are applied
to only the user line and take precedence
over the user-defined default settings. If a
parameter is not configured in user line
view or user line class view, the factory
default setting is used.
Settings in a user line view take effect
immediately and affect the online user.
Settings in the line class view do not affect
online users and take effect only for users
who log in after the configuration is
completed.
3. Enable scheme
authentication.
authentication-mode scheme
On a device with both AUX and console
lines, authentication is disabled for the
console line and password authentication
is enabled for the AUX line by default.
On a device that has one AUX line and
does not have a console line,
authentication is disabled for the AUX line
by default.
To use scheme authentication, you must also configure login authentication methods in ISP domain view.
For more information, see Security Configuration Guide.
The next time you attempt to log in through the console or AUX port, you must provide the configured
login username and password, as shown in Figure 18 and Figure 19.
Figure 18 Schem
e authentication interface for console login