HP MSR2000/3000/4000 Router Series Fundamentals Configuration Guide

71
Ste
p
Command Remarks
2. Enter user line view or
user line class view.
• To enter user line view:
line { first-number1
[ last-number1 ] | { aux |
console | tty | vty }
first-number2 [ last-number2 ] }
• To enter user line class view:
line class { aux | console | tty
| vty }
Use either command.
Settings configured in a user line class view
are applied as user-defined default settings
to all user lines of the line class. Settings
configured in a user line view are applied
to only the user line and take precedence
over the user-defined default settings. If a
parameter is not configured in user line
view or user line class view, the factory
default setting is used.
Settings in a user line view take effect
immediately and affects the online user.
Settings in the line class view do not affect
online users and take effect only for users
who log in after the configuration is
completed.
3. Enable scheme
authentication.
authentication-mode scheme
On a device with both AUX and console
lines, authentication is disabled for the
console line and password authentication
is enabled for the AUX line by default.
On a device that has one AUX line and
does not have a console line,
authentication is disabled for the AUX line
by default.
4. Enable command
accounting.
command accounting
By default, command accounting is
disabled, and the accounting server does
not record the commands executed by
users.
Configuration example
Network requirements
To monitor and control user operations on the device in Figure 35, configure the device to send
commands executed by users to the HWTACACS server.