4000 Router Series High Availability Command Reference

VRRP priority is in the range of 0 to 255, and a greater number represents a higher priority. Priorities 1

to 254 are configurable. Priority 0 is reserved for special uses, and priority 255 is for the IP address

owner. The router acting as the IP address owner in a VRRP group always has a running priority of 255

and acts as the master as long as it operates correctly.

Examples

# Configure the priority of the router in VRRP group 1 on Ethernet 1/1 to 150.

<Sysname> system-view

[Sysname] interface ethernet 1/1

[Sysname-Ethernet1/1] vrrp ipv6 vrid 1 priority 150

Related commands

display vrrp ipv6

vrrp ipv6 vrid shutdown

Use vrrp ipv6 vrid shutdown to disable an IPv6 VRRP group.

Use undo vrrp ipv6 vrid shutdown to restore the default.

Syntax

vrrp ipv6 vrid virtual-router-id shutdown

undo vrrp ipv6 vrid virtual-router-id shutdown

Default

An IPv6 VRRP group is enabled.

Views

Interface view

Predefined user roles

network-admin

Parameters

virtual-router-id: Specifies an IPv6 VRRP group by its virtual router ID in the range of 1 to 255.

Usage guidelines

You can use this command to temporarily disable an IPv6 VRRP group. After this command is configured,

the VRRP group stays in initialized state, and its configurations remain unchanged. You can change its

configuration, and your changes take effect when you enable the VRRP group again.

Examples

# Disable IPv6 VRRP group 1.

<Sysname> system-view

[Sysname] interface ethernet 1/1

[Sysname-Ethernet1/1] vrrp ipv6 vrid 1 shutdown

vrrp ipv6 vrid timer advertise

Use vrrp ipv6 vrid timer advertise to configure the interval at which the master in an IPv6 VRRP group

sends VRRP advertisements.