HP MSR2000/3000/4000 Router Series Interface Command Reference

94
Parameters
interface-number: Specifies a CE1/PRI interface by its number. If you do not specify this argument, the
command clears the controller counter for all CE1/PRI interfaces.
Usage guidelines
The reset counters interface command clears the counters of all interfaces. To clear the controller counter
of individual CE1/PRI interfaces, use the reset counters controller e1 command.
Examples
# Clear the controller counter for CE1/PRI interface E1 2/0.
<Sysname> reset counters controller e1 2/0
Related commands
display controller e1
using (CE1/PRI interface)
Use using to set the operating mode of a CE1/PRI interface.
Use undo using to restore the default.
Syntax
using { ce1 | e1 }
undo using
Default
A CE1/PRI interface operates in CE1/PRI mode.
Views
CE1/PRI interface view
Predefined user roles
network-admin
Parameters
ce1: Sets the interface to operate in CE1/PRI mode.
e1: Sets the interface to operate in E1 mode.
Usage guidelines
A CE1/PRI interface can operate in either E1 mode (non-channelized mode) or CE1/PRI mode
(channelized mode).
In E1 mode, the interface equals a 2.048 Mbps interface without timeslot division and has the same
logical features as a synchronous serial interface. In CE1/PRI mode, the CE1/PRI interface is physically
divided into 32 timeslots numbered 0 through 31, where timeslot 0 is used for FSC. This interface can
operate as either a CE1 interface or a PRI interface.
After you set the CE1/PRI interface to operate in E1 mode, the system automatically creates a serial
interface numbered serial interface-number:0, where interface-number represents the number of the
CE1/PRI interface.
Examples
# Set CE1/PRI interface E1 2/0 to operate in E1 mode.