HP MSR2000/3000/4000 Router Series Interface Command Reference

125
[Sysname-Serial2/0] crc 32
display ft1
Use display ft1 to display information about a T1-F interface.
Syntax
display ft1 [ serial interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
serial interface-number: Specifies a T1-F interface by its number. If you do not specify any interface, this
command displays information about all T1-F interfaces.
Usage guidelines
If the specified interface is a common serial interface rather than a T1-F interface, the system displays a
prompt.
Examples
# Display information about T1-F interface Serial 2/0.
<Sysname> display ft1 serial 2/0
Serial2/0
Input:
0 packets, 0 bytes
0 broadcasts, 0 multicasts
0 errors, 0 runts, 0 giants
0 CRC, 0 align errors, 0 overruns
0 aborts, 0 no buffers
0 frame errors
Output:
0 packets, 0 bytes
0 errors, 0 underruns, 0 collisions
0 deferred
Basic Configuration:
Work mode: T1 framed, Cable type: 100 Ohm balanced
Frame-format: esf, fdl: none, Line code: b8zs
Source clock: slave, Data-coding: normal
Idle code: ff, Itf type: ff, Itf number: 2
Loopback: not set
Alarm State:
Receiver alarm state is Loss-of-Signal.
Transmitter is sending remote alarm.
Pulse density violation detected.
SendLoopCode History: