HP MSR2000/3000/4000 Router Series Interface Command Reference

162
Field Descri
p
tion
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec,
0 packets/sec
Input rate in Bps, bps, and pps in the last 300
seconds.
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec,
0 packets/sec
Output rate in Bps, bps, and pps in the last 300
seconds.
Input:
0 packets, 0 bytes
0 errors, 0 runts, 0 giants, 0 CRC
0 overruns, 0 aborts, 0 no buffers
Count of input traffic in both packets and bytes:
• errors—Number of inbound packets with errors
detected at the physical layer.
• runts—Number of inbound frames shorter than the
minimum frame length.
• giants—Number of inbound frames larger than the
maximum frame length.
• CRC—Total number of inbound frames that had
normal length and contained CRC errors.
• overruns—Number of frames dropped because
the input rate of the port exceeded the forwarding
capability.
• aborts—Total number of illegal inbound frames.
• no buffers—Number of frames that are dropped
because the buffer is used up.
Output:
0 packets, 0 bytes
0 errors, 0 underruns, 0 aborts
Count of output traffic in both packets and bytes:
• errors—Number of outbound frames with errors
detected at the physical layer.
• underruns—Number of packets dropped because
the output rate of the interface exceeded the
memory reading rate.
• aborts—Total number of illegal inbound frames.
Brief information on interface(s) under route mode: Brief information about Layer 3 interfaces.
Link: ADM - administratively down; Stby - standby
Link status:
• ADM—The interface has been administratively
shut down. To recover its physical state, perform
the undo shutdown command.
• Stby—The interface is operating as a backup
interface. To see the primary interface, use the
display standby state command described in High
Availability Command Reference.
Protocol: (s) - spoofing
If the network layer protocol state of an interface is
shown as UP, but its link is an on-demand link or not
present at all, its protocol attribute includes the
spoofing flag (an s in parentheses).
Interface Abbreviated interface name.
Link
Physical link state of the interface:
• UP—The link is up.
• ADM—The link has been administratively shut
down. To recover its physical state, perform the
undo shutdown command.
Protocol
Protocol connection state of the interface, which can
be UP, DOWN, or UP(s).