4000 Router Series Interface Command Reference

ManualsBrandsHP ManualsNetwork HardwareHP MSR3024 TAA-compliant AC Router

Field Description

Link speed type is autonegotiation The interface is configured with the speed auto command.

Link speed type is force link

The interface is configured with a specific speed, for example, 10

Mbps or 100 Mbps, by using the speed command.

link duplex type is autonegotiation The interface is configured with the duplex auto command.

link duplex type is force link

The interface is configured with a specific duplex mode, for

example, half or full, by using the duplex command.

The Maximum Frame Length Maximum Ethernet frame length allowed on the interface.

Allow jumbo frame to pass The interface allows jumbo frames to pass through.

Broadcast MAX-

Broadcast storm suppression threshold in ratio, pps, or kbps. The

unit of the threshold depends on your configuration.

Multicast MAX-

Multicast storm suppression threshold in ratio, pps, or kbps. The

unit of the threshold depends on your configuration.

Unicast MAX-

Unicast storm suppression threshold in ratio, pps, or kbps. The unit

of the threshold depends on your configuration.

PVID Port VLAN ID (PVID) of the Ethernet interface.

Mdi type

Cable type (depending on your configuration):

• automdix.

• mdi.

• mdix.

Port link-type

Link type of the interface (depending on your configuration):

• access.

• trunk.

• hybrid.

Tagged VLAN ID

VLANs for which the interface sends packets without removing

VLAN tags.

Untagged VLAN ID

VLANs for which the interface sends packets after removing VLAN

tags.

Port priority Priority of the interface.

Last clearing of counters: Never

Time when the reset counters interface command was last used to

clear statistics on the interface. Never indicates that the reset

counters interface command was never used since the device was

started.

Peak value of input

Peak rate of inbound traffic in Bps, and the time when the peak

inbound traffic rate occurred.

Peak value of output

Peak rate of outbound traffic in Bps, and the time when the peak

outbound traffic rate occurred.

Last 300 seconds input: 0 packets/sec 0

bytes/sec 0%

Last 300 seconds output: 0 packets/sec

0 bytes/sec 0%

Average rate of inbound and outbound traffic in the last 300

seconds, in pps and Bps, and the ratio of the actual rate to the

maximum interface rate.

A hyphen (-) indicates that the statistical item is not supported.