HP MSR2000/3000/4000 Router Series Interface Command Reference

36
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] mac-address 1-1-1
mdix-mode
IMPORTANT:
Fiber ports do not support this command.
Use mdix-mode to configure the Medium Dependent Interface Cross-Over (MDIX) mode of an Ethernet
interface.
Use undo mdix-mode to restore the default.
Syntax
mdix-mode { automdix | mdi| mdix }
undo mdix-mode
Default
Ethernet interfaces operate in automdix mode.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
automdix: Specifies that the interface negotiates pin roles with its peer.
mdi: Specifies that pins 1 and 2 are transmit pins and pins 3 and 6 are receive pins.
mdix: Specifies that pins 1 and 2 are receive pins and pins 3 and 6 are transmit pins.
Examples
# Set Ethernet 1/1 to operate in MDI mode.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] mdix-mode mdi
multicast-suppression
Use multicast-suppression to enable multicast storm suppression and set the multicast storm suppression
threshold.
Use undo multicast-suppression to restore the default.
Syntax
multicast-suppression { ratio | pps max-pps | kbps max-kbps }
undo multicast-suppression