HP MSR2000/3000/4000 Router Series Interface Command Reference

56
Link: ADM - administratively down; Stby - standby
Interface Link Cause
S2/0 ADM Administratively
Table 11 Command output
Field Descri
p
tion
Serial2/0
Current state
Current physical and administrative states of the serial
interface, which can be one of the following:
• DOWN (Administratively)—The serial interface was shut
down with the shutdown command.
• DOWN—The serial interface is physically down because
no physical link is present or the physical link has failed.
• UP—The serial interface is both administratively and
physically up.
Line protocol current state Link protocol state of the serial interface.
Description Description of the serial interface.
Bandwidth Intended bandwidth of the interface.
Maximum Transmit Unit MTU on the serial interface.
Hold timer Interval at which the interface sends keepalive packets.
Internet Address IP address of the serial interface.
Link layer protocol Link layer protocol of the serial interface.
LCP: opened A PPP connection is established successfully.
Last clearing of counters: Never
Time when the reset counters interface command was last
executed. If the device has never executed the reset counters
interface command, the field displays Never.
Physical layer Physical layer state.
Baudrate Baudrate of the interface.
Output queue : (Urgent queuing :
Size/Length/Discards) 0/100/0
Urgent queuing specifies the current number of packets in the
queue, maximum number of packets that can stay in the
queue, and number of dropped packets.
Link layer protocol packets, such as PPP negotiation packets
and keepalive packets enter this queue.
Output queue : (Protocol queuing :
Size/Length/Discards) 0/500/0
Protocol queuing specifies the current number of packets in the
queue, maximum number of packets that can stay in the
queue, and number of dropped packets.
Packets with IP precedence 6 enter this queue.
Output queue : (FIFO queuing :
Size/Length/Discards) 0/75/0
FIFO queuing specifies the current number of packets in the
first-in first-out (FIFO) queue, maximum number of packets that
can stay in the queue, and number of dropped packets.
Interface: DCE
Cable type: V35
Clock mode: DCECLK
Synchronizes the clock mode on the DCE side of the serial
interface.
Last 300 seconds input rate 2.40 bytes/sec,
19 bits/sec, 0.20 packets/sec
Average input rate in the last 300 seconds.