HP MSR2000/3000/4000 Router Series Interface Command Reference

69
Syntax
async-mode { flow | protocol }
undo async-mode
Default
An AM interface operates in flow mode.
Views
AM interface view
Predefined user roles
network-admin
Parameters
flow: Configures the interface to operate in flow mode, or named interactive mode. In this mode, the two
ends interact attempting to set up a link after the physical link is set up. During this process, the calling
party sends configuration commands to the called party (this is equal to the operation of manually
inputting configuration commands at the remote end), sets the link layer protocol operating parameters
of the called party, and then sets up the link. This approach applies to man-machine interactions such as
dial-in access.
protocol: Configures the interface to operate in protocol mode. In protocol mode, the interface uses
configured link layer protocol parameters to set up a link with the remote end after its physical link is
established.
Examples
# Configure AM interface Analogmodem 6/3/0 to operate in flow mode.
<Sysname> system-view
[Sysname] interface analogmodem 6/3/0
[Sysname-Analogmodem6/3/0] async-mode protocol
display interface analogmodem
Use display interface analogmodem to display information about an AM interface.
Syntax
display interface [ analogmodem ] [ brief [ down | description ] ]
display interface [ analogmodem [ interface-number ] ] [ brief [ description ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-number: Specifies an AM interface by its number.
brief: Displays brief interface information. If you do not specify this keyword, the command displays
detailed interface information.