HP MSR2000/3000/4000 Router Series Interface Command Reference

79
Field Description
Input:
0 packets, 0 bytes
0 errors, 0 runts, 0 giants,
0 crc, 0 align errors, 0 overruns,
0 aborts, 0 no buffers
0 frame errors
Received statistics on the BRI interface:
• errors—Number of error packets detected on the physical
layer.
• runts—Number of undersized packets received on the
interface.
• giants—Number of oversized packets received on the
interface.
• crc—Number of normal-sized packets with CRC errors received
on the interface.
• align errors—Number of packets with alignment errors
received on the interface.
• overruns—Number of packets dropped because the input rate
of the interface exceeded the queuing capability.
• aborts—Number of packets that are not received successfully.
• no buffers—Number of packets that are discarded because
the buffer runs out.
• frame errors—Number of packets with frame errors.
Output:
0 packets, 0 bytes
0 errors, 0 underruns, 0 collisions
0 deferred
Sent statistics on the BRI interface:
• errors—Number of error packets detected at the physical layer.
• underruns—Number of packets that fail to be forwarded
because the interface reads from memory at a slower speed
than it forwards packets.
• collisions—Number of packets with collisions detected.
• deferred—Number of deferred or timeout packets.
Brief information of interface(s) under
route mode:
Brief information about Layer 3 interfaces.
Link: ADM - administratively down; Stby -
standby
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, perform the undo shutdown
command.
• Stby—The interface is operating as a backup interface. To see
the primary interface, use the display standby state command
in High Availability Command Reference.
Protocol: (s) - spoofing
If the network layer protocol state of an interface is shown as UP,
but its link is an on-demand link or not present at all, its protocol
attribute includes the spoofing flag (an s in parentheses).
Interface Abbreviated interface name.
Link
Physical link state of the interface:
• UP—The link is up.
• ADM—The link has been administratively shut down. To
recover its physical state, perform the undo shutdown
command.
Protocol Protocol connection state of the interface: UP or DOWN.
Main IP Main IP address of the interface.
Description Description of the interface.