4000 Router Series Interface Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP MSR3024 TAA-compliant AC Router

Step Command Remarks

4. Bundle timeslots on the

interface into a channel set.

channel-set set-number timeslot-list

list

By default, no channel set is

created.

The timeslots on a CE1/PRI

interface can be bundled into

either channel sets or a PRI set, but

not the both, at a time.

5. Set the framing format.

frame-format { crc4 | no-crc4 } The default is no-CRC4.

6. (Optional.) Enable RAI

detection on the interface.

alarm detect rai

By default, RAI detection is

enabled on the interface.

7. (Optional.) Set other interface

parameters.

See "Configuring other CE1/PRI

interface parameters."

N/A

A CE1/PRI interface operating in CE1/PRI mode can be used as a CE1 interface where a serial interface

is created upon creation of a channel set. You can bundle timeslots on a CE1/PRI interface into up to 31

channel sets.

For each channel set, the system automatically creates a serial interface numbered serial

interface-number:set-number. This interface is logically equivalent to a synchronous serial interface

where you can make other configurations such as:

• Data link protocol such as PPP

• IP addressing

• Backup center settings if the interface is used as a primary or secondary interface for backup

• NAT and packet filtering if a firewall is to be set up

Configuration procedure (in PRI mode)

To configure a CE1/PRI interface in PRI mode:

Step Command Remarks

1. Enter system view.

system-view N/A

2. Enter CE1/PRI interface view.

controller e1 number N/A

3. Configure the interface to

operate in CE1/PRI mode.

using ce1

The default operating mode is

CE1/PRI mode.

4. Bundle timeslots on the

interface into a PRI set.

pri-set [ timeslot-list list ]

By default, no PRI set is created.