HP MSR2000/3000/4000 Router Series Interface Module Guide

106
FIC-1POS
Introduction
FIC-1POS, the 1-port SDH/SONET interface module, supports interface rates up to 155.52 Mbps
(STM-1/OC-3).
The FIC-1POS uses the protocols such as PPP, Frame Relay and HDLC at the data link layer and IP at the
network layer. It allows direct transmission of packets over SONET/SDH. It supports:
• Four types of SFP: multi-mode short-haul (1310 nm), single mode medium-haul (1310 nm), single
mode long-haul (1310 nm), and single-mode ultra-long haul (1550 nm).
• 155.52 Mbps fractional interface
Interface attributes
The following table describes the interface attributes of the FIC-1POS. For more information about the
attributes of the optional SFP transceiver modules, see "100-Mbps SFP transceiver module."
Table 155 Interface attributes of the FIC-1POS
Attribute FIC-1POS
Connector SFP/LC
Interface standard SONET OC-3/SDH STM-1
Number of
interfaces
1
Interface rate 155.52 Mbps
Interface LEDs
The following figure illustrates the FIC-1POS panel:
Figure 113 FIC-1POS panel
The following table describes the LEDs on the FIC-1POS panel.
Table 156 LEDs on the FIC-1POS panel
LED Descri
p
tion
LINK/ACT
• ON means carrier signal has been received.
• Flashing means data is being received or/and transmitted.
• OFF means no carrier signal has been received.
LP/AL
• ON means the interface is in a loopback.
• Flashing means an AIS, LFA, or RAI alarm signal is present.
• OFF means no loopback or alarm is present.