HP MSR2000/3000/4000 Router Series Interface Module Guide

138
NOTE:
Strictly follow the pinouts in the above tables when identifyin
g
or makin
g
the two types of Ethernet cables;
otherwise, the communication quality may be affected.
Connecting an Ethernet cable
1. Connect one end of an Ethernet cable to an Ethernet interface on the module and the other end to
the Ethernet interface on the peer device. Because the Ethernet interface of the module supports
MDI/MDIX auto-sensing, you can use a straight-through cable or crossover cable to connect the
interface.
2. Check the status of the LED of the Ethernet interface after power-on. For the status of the LED, see
the relevant part in this manual.
Fiber port
Appearances and applicable models of transceiver modules and optical fibers
Optical interfaces must work with SFP transceiver modules and optical fibers with LC connectors.
Table 200 Ethernet cable appearance and applicable models
Product
number
Cable Appearance
Applicable
models
JD090A
JD091A
JD102B
JD120B
SFP transceiver
module
• JD090A
• JD091A
• JD102B
• JD120B
SIC-1FEF
MIM-1POS
FIC-1POS
FIC-1CPOS
HMIM-1POS
MIM-1ATM-OC3
FIC-1ATM-OC3
JD118B
JD119B
JD061A
JD062A
JD063B
JD103A
JD098B
JD099B
SFP transceiver
module
• JD118B
• JD119B
• JD061A
• JD062A
• JD063B
SIC-1GEC
FIC-1GEF
FIC-2GEF
100-Mbps SFP transceiver module
A 100-Mbps SFP transceiver module uses LC connectors.