HP MSR2000/3000/4000 Router Series Interface Module Guide

151
E3/T3 interface
E3/T3 cable appearance and applicable models
Table 207 E3/T3 cable appearance and applicable models
Product
numbe
r
Cable Appearance
Applicabl
e models
JD531A
JD533A
E3/T3
interfac
e cable
1 x BNS < ---- > 1 x SMB
MIM-1CE3
MIM-1CT3
FIC-1CE3
FIC-1CT3
FIC-1AE3
FIC-1AT3
HMIM-1CE
3
HMIM-1CT
3
Connecting the cable
1. Connect the SMB connector of an E3/T3 cable to the Tx port on the interface module and another
end to the Rx port on the device to be connected.
2. Connect the SMB connector of another E3/T3 cable to the Rx port of interface module and another
end to the Tx port on the device to be connected;
3. Check the LINK LED on the module panel. It is off when fault has occurred on the link and signal
is out of synchronization. In this case, check the link.
Synchronous/asynchronous serial ports
Appearance and applicable models of synchronous/asynchronous serial port cables
Table 208 Appearance and applicable models of synchronous/asynchronous serial port cables
Product
number
Cable Appearance
Applicable
models
JD519A
V.24
DTE
cable
1 x D25 (male) < ---- > 1 x D28
SIC-1SAE
SIC-2SAE
SIC-4SAE
MIM-2SAE
MIM-4SAE
MIM-8SAE