HP MSR2000/3000/4000 Router Series IP Multicast Command Reference

24
Views
VLAN view
Predefined user roles
network-admin
Parameters
interval: Sets an aging timer for the dynamic router ports in a VLAN, in the range of 1 to 1000 seconds.
Usage guidelines
You must enable IGMP snooping for a VLAN before you execute this command for the VLAN.
The configuration made in VLAN view takes effect only on the current VLAN and takes preference over
the global configuration.
Examples
# Enable IGMP snooping for VLAN 2 and set the aging timer for the dynamic router ports in the VLAN
to 100 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping router-aging-time 100
Related commands
• igmp-snooping enable
• router-aging-time (IGMP-snooping view)
igmp-snooping static-group
Use igmp-snooping static-group to configure a port as a static member port of the specified multicast
group or the specified multicast source and group.
Use undo igmp-snooping static-group to restore the default.
Syntax
igmp-snooping static-group group-address [ source-ip source-address ] vlan vlan-id
undo igmp-snooping static-group group-address [ source-ip source-address ] { all | vlan vlan-id }
Default
A port is not a static member port of any multicast group or multicast source and group.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
group-address: Specifies a multicast group by its IP address in the range of 224.0.1.0 to
239.255.255.255.