HP MSR2000/3000/4000 Router Series IP Multicast Command Reference

45
Parameters
source: Specifies load splitting on a per-source basis.
source-group: Specifies load splitting both on a per-source basis and on a per-group basis.
Examples
# Enable load splitting of multicast traffic on a per-source basis on the public network.
<Sysname> system-view
[Sysname] multicast routing
[Sysname-mrib] load-splitting source
longest-match (MRIB view)
Use longest-match to configure the device to select the RPF route based on the longest prefix match
principle.
Use undo longest-match to restore the default.
Syntax
longest-match
undo longest-match
Default
The device selects the route with the highest priority as the RPF route.
Views
MRIB view
Predefined user roles
network-admin
Examples
# Configure the device to select the RPF route based on the longest prefix match principle on the public
network.
<Sysname> system-view
[Sysname] multicast routing
[Sysname-mrib] multicast longest-match
mac-address multicast
NOTE:
This command is available only on the MSR series routers with Ethernet Layer 2 switching interface
modules. For information about the Ethernet Layer 2 switching interface modules, see
HP MSR Router
Series Interface Module Guide
.
Use mac-address multicast to configure a static multicast MAC address entry.
Use undo mac-address multicast to delete a static multicast MAC address entry.
Syntax
In system view: