4000 Router Series IP Multicast Command Reference

• 2msdp: Specifies PIM routing entries to be contained in the next SA message to notify an MSDP

peer.

• act: Specifies PIM routing entries that have been used for routing data.

• del: Specifies PIM routing entries to be deleted.

• exprune: Specifies PIM routing entries containing outgoing interfaces pruned by other multicast

routing protocols.

• ext: Specifies PIM routing entries containing outgoing interfaces provided by other multicast routing

protocols.

• loc: Specifies PIM routing entries on the devices that reside on the same subnet as the multicast

source.

• msdp: Specifies PIM routing entries learned from MSDP SA messages.

• niif: Specifies PIM routing entries containing unknown incoming interfaces.

• nonbr: Specifies PIM routing entries with PIM neighbor lookup failure.

• rpt: Specifies PIM routing entries on the RPT branches where (S, G) prunes have been sent to the RP.

• rq: Specifies PIM routing entries of the receiving side of the switch-MDT switchover.

• spt: Specifies PIM routing entries on the SPT.

• sq: Specifies PIM routing entries of the originator side of switch-MDT switchover.

• swt: Specifies PIM routing entries in the process of RPT-to-SPT switchover.

• wc: Specifies PIM routing entries with wildcards.

fsm: Displays detailed information about the finite state machine.

incoming-interface interface-type interface-number: Specifies an incoming interface. If you do not

specify an incoming interface, this command displays PIM routing entries that contain all incoming

interfaces.

mode mode-type: Specifies a PIM mode. If you do not specify a PIM mode, this command displays PIM

routing entries in all PIM modes. The available PIM modes include:

• dm: Specifies PIM-DM.

• sm: Specifies PIM-SM.

• ssm: Specifies PIM-SSM.

outgoing-interface { exclude | include | match } interface-type

terface-number: Specifies an outgoing

interface. If you do not specify an outgoing interface, this command displays PIM routing entries that

contain all outgoing interfaces. Whether the specified outgoing interface is contained in the PIM routing

table depends on the following conditions:

• If you specify an excluded interface, this command displays PIM routing entries that do not contain

the specified outgoing interface.

• If you specify an included interface, this command displays PIM routing entries that contain the

specified outgoing interface.

• If you specify a matching interface, this command displays PIM routing entries that contain only the

specified outgoing interface.

Examples

# Display PIM routing table information on the public network.

<Sysname> display pim routing-table

Total 0 (*, G) entry; 1 (S, G) entry