HP MSR2000/3000/4000 Router Series IP Multicast Configuration Guide

93
Eth1/4 10.110.3.1
/
24 Eth1/3 10.110.7.2
/
24
Router C Eth1/1 192.168.3.1/24 Router F Eth1/1 10.110.9.1/24
Eth1/2 10.110.4.1
/
24 Eth1/2 10.110.8.2
/
24
Eth1/3 10.110.5.1
/
24 Eth1/3 10.110.3.2
/
24
Eth1/4 10.110.2.2/24 Router G Eth1/1 192.168.5.1/24
Eth1/5 10.110.6.1
/
24 Eth1/2 10.110.9.2
/
24
Router H Eth1/1 10.110.10.1
/
24 Source 1 - 192.168.2.10/24
Eth1/2 10.110.6.2/24 Source 2 - 192.168.3.10/24
Router I Eth1/1 192.168.6.1/24 Source 3 - 192.168.5.10/24
Eth1/2 10.110.10.2
/
24
Configuration procedure
1. Assign an IP address and subnet mask to each interface according to Figure 35. (Details not
shown.)
2. Enable OSPF on all routers on the PIM-SM network to make sure the network-layer on the PIM-SM
network is interoperable and the routing information among the routers can be dynamically
updated. (Details not shown.)
3. Enable IP multicast routing, IGMP, and PIM-SM:
# On Router A, enable IP multicast routing globally, enable IGMP on Ethernet 1/1, and enable
PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast routing
[RouterA-mrib] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] pim sm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim sm
[RouterA-Ethernet1/2] quit
# Enable IP multicast routing, IGMP and PIM-SM on Router E and Router I in the same way Router
A is configured. (Details not shown.)
# On Router B, enable IP multicast routing globally, and enable PIM-SM on each interface.
<RouterB> system-view
[RouterB] multicast routing
[RouterB-mrib] quit
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] pim sm
[RouterB-Ethernet1/1] quit
[RouterB] interface ethernet 1/2
[RouterB-Ethernet1/2] pim sm
[RouterB-Ethernet1/2] quit
[RouterB] interface ethernet 1/3
[RouterB-Ethernet1/3] pim sm
[RouterB-Ethernet1/3] quit
[RouterB] interface ethernet 1/4
[RouterB-Ethernet1/4] pim sm