HP MSR2000/3000/4000 Router Series IP Multicast Configuration Guide

106
condition for the IPv6 multicast groups in the specified range or scope. If the destination address of an
IPv6 multicast packet matches the set boundary condition, the packet is not forwarded. Once an IPv6
multicast boundary is configured on an interface, this interface can no longer forward IPv6 multicast
packets (including those sent from the local device) or receive IPv6 multicast packets.
TIP:
You do not need to enable IPv6 multicast routing before this configuration.
To configure an IPv6 multicast forwarding boundary:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure an IPv6 multicast
forwarding boundary.
ipv6 multicast boundary
{ ipv6-group-address prefix-length
| scope { scope-id | admin-local |
global | organization-local |
site-local } }
By default, no forwarding
boundary is configured.
Configuring IPv6 static multicast MAC address entries
This feature is available only on the MSR series routers with Ethernet Layer 2 switching interface modules.
For information about the Ethernet Layer 2 switching interface modules, see HP MSR Router Series
Interface Module Guide.
In Layer-2 multicast, a Layer-2 IPv6 multicast protocol (such as MLD snooping) can dynamically add IPv6
multicast MAC address entries. Or, you can manually configure IPv6 multicast MAC address entries.
TIP:
• You do not need to enable IPv6 multicast routing before this configuration.
• The IPv6 multicast MAC address that can be configured in the MAC address entry must be unused. (The
least significant bit of the most significant octet is 1.)
You can configure IPv6 static multicast MAC address entries on the specified interface in system view, or
on the current interface in interface view.
To configure an IPv6 static multicast MAC address entry in system view:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Configure a static multicast
MAC address entry.
mac-address multicast
mac-address interface interface-list
vlan vlan-id
By default, no static multicast MAC
address entries exist.
To configure an IPv6 static multicast MAC address entry in interface view: